Half-cut or full-cut: choosing the right die-cutting route
Two die-cutting methods, two different assembly problems. Choosing the wrong one costs either cycle time or part handling.
In half-cut die cutting the blade cuts through the material and the adhesive but leaves the release liner intact. Parts stay on the roll in register, so an automated line can peel and place them one by one without a feeder full of loose pieces. It is the usual choice for EVA foam, silicone sheet, PET and adhesive laminates that feed a pick-and-place station.
Full-cut die cutting severs the material and its liner, producing singulated parts. That suits manual assembly, bagged kits and parts that are packed by count, and it is easier to inspect dimensionally because every piece can be measured on its own.
The material often decides. Thin films and foams behave well on rotary lines at speed; thick silicone sheet or bakelite may need flatbed cutting or CNC routing instead. Send the drawing and the assembly method and we will say which route holds the tolerance at your volume.
Selection notes
- Half-cut: parts stay on the liner for automated pick-and-place
- Full-cut: singulated parts for manual assembly or kits
- Material thickness and backing decide rotary versus flatbed